Barry-Wehmiller Thiele Technologies Streamfeeder Reliant..., Руководство пользователя

Страница: 18 / 72

12 R
eliant
1500 M
anual
• Using the two provided hold-down spring assemblies (with support
bars), place each on the insert station rail (feeder side of inserter).
• Position each spring support bar so that they are equally spaced
from each edge of the material to be run.
• Tighten the built-in wing nut on each to secure.
• Check for placement and pressure of the hold-down spring as
-
semblies by sliding a piece of material to be run under the springs.
There should be a “slight drag” when moving the material back and
forth.
• Make adjustments as required and recheck. See Figure 11.
STEP 6:
Installing Feeder
Hold-Down Spring
Assemblies
NO TE
Figure 11. Installing Hold-Down Spring Assemblies and
Testing for Drag
Feeder
hold-down
spring
Feeder
hold-down
springs
Use this configuration
for Bell & Howell
Mailstars, and 825
models.
Knowing how far from each edge of the material
to place the hold-down spring assemblies is a
combination of intuition and testing.
TIP
With material inserted between the springs and
the insert guide tabs, test the spring tension by
sliding the material back and forth. Tension
should not be so great that it distorts the material
as it moves.
If adjustment is required, loosen the hex-head
screw for each spring and move up or down on
support bar. Retighten when optimum tension is
achieved.
TIP
Certain inserter models require hold-down spring
assemblies to mount from the bottom side of the
cross-bar (see figure below). To invert, simply
remove screw and invert L-bracket and spring.