Dispense Overflow Cutoff Float
Accessory AY1367X1 (overflow float with 6 ft. [1.83 meter]
cable) is designed as a user option to ensure automatic
dispensers (time or volumetric) do not overflow carboy
style containers. This accessory can be especially helpful
if the actual volume of a container is unknown. It can
also protect against overflows if the entered/stored vol-
ume of a previous container has not been changed and is
set for a volume greater than the carboy being filled.
Finally, the accessory can be useful for automatic time
dispenses as it is usually difficult to ensure the set time
will equal a specific volume of water.
1.
Prior to initiating an automatic dispense (timed
or volumetric), plug AY1367X1 into connector on
the back left side of the DIamond TII.
2.
Position carboy to be filled and place float
assembly on open neck of carboy. Position float
assembly such that it will not interfere with prod-
uct water stream being dispensed into carboy.
3.
Initiate Auto Dispense as described in the
“Automatic Dispensing” section of this manual. If
during the auto dispense the float is lifted by the
rising water, the auto dispense will immediately
be stopped and an error message will be dis-
played momentarily.
23
I
NSTALLATION
Caution
This accessory is not intended for
use with small containers as its
weight could cause small, light-
weight containers to tip over.
Note
If an auto dispense is stopped by
the AY1367X1, the DIamond TII will
change modes to normal recircula-
tion.
SYSTEM
DIAMOND TII
CUTOFF FLOAT
DISPENSE OVERFLOW
AY1367X1
Figure 16: AY1367X1 Dispense Overflow Cutoff Float