Barnstead|Thermolyne NANOpure DIamond D11951, Руководство по эксплуатации

Страница: 29 / 56

29
UP arrow: +1 up to 5 min., then increments by 5 minutes
DOWN arrow: Decrement by 1 minute
Maximum: 40 minutes
Minimum: 1 minute
Performing a System Flush
1. From the normal recirculating mode, when the
display is showing purity, press the UP or
DOWN arrow until the display reads, “System
Flush?” Press ENTER.
2. Press the UP or DOWN arrow to select “Short
Flush?” or “Extended Flush?” Press ENTER.
3. Display will read, “System Flushing: (xxx)
Seconds or (xxx) Minutes Remaining.”
Changing Purity Units
(Factory set to “M
Ω
-cm.”)
1. From the normal recirculating mode, when the
display is showing purity, press the Up or
DOWN arrow until display will reads, “Change
Units?” Press ENTER.
2. Press the UP or DOWN arrow to select “M
Ω
-cm”
or “uS/cm” Press ENTER.
3. Press BACK to return to the normal recirculating
mode.
Temperature Compensation
(Factory set to “ON.”)
1. From the normal recirculating mode, when the
display is showing purity, press the Up or
DOWN arrow until the display reads,
“Temperature Compensation?” Press ENTER.
2. Press the UP or DOWN arrow to select “OFF”
or “ON” Press ENTER.
3. Press BACK to return to the normal recirculating
mode.
U
SER
S
ETTINGS
Note
Purity displayed will have an asterisk
(*) the the left of the reading (* xx.x
M
Ω
-cm or * x.xx uS/cm) to inform the
user that uncompensated purity is
being displayed.
Note
Press the STOP/STOP switch to can-
cel the flush.