
Installation / start-up
Barkey GmbH & Co. KG - Gewerbestrasse 8 - 33818 Leopoldshoehe - Germany - Telephone: +49(0)5202-9801-0
21
Service department: +49(0)5202-9801-30 Fax: +49 (0)5202-9801-99 - email: [email protected]
Instructions for Use
Barkey S-line
►
Fasten the Barkey S-line close to the infusion line on the infusion stand so that the
receiver for the head of the warming section (left next to the control unit) points to the infusion
line.
►
Place the device with the clamp on the infusion stand. The infusion stand must be
in contact with the bottom of the fastening slot. If the fastening screw is in the way, unscrew it
from the slot by turning in an anti-clockwise direction (Fig. 6).
►
Fix the device in place by tightening the fastening screw in a clockwise direction
(Fig. 6).
WARNING
Do not clamp lines or tubes in the fastening slot.
Screw the fastening screw so that the device is firmly fixed to the infusion stand. If the device is
not firmly fixed in place it may be difficult to use it and it may dislodge.
Fig. 6: Fitting the control unit to the infusion stand
►
Hang the free ends of the warming section (head and end) in the recess, on the left
next to the control unit (Fig. 7).
►
Place the head of the warming section from above into the holder so that the
warming section runs downwards (Fig. 7; sketches 1 to 3).
►
Place the end of the warming section from above into the holder for the end so that
the warming section runs downwards (Fig. 7; sketches 4 to 6).