70
ImagePRO-II • User’s Guide
4. Menu Orientation
Working with Test Patterns
oÉëíçêáåÖ=lìíéìí=`çåÑáÖìê~íáçå=aÉÑ~ìäí=s~äìÉë
To remove user-defined configuration settings and restore the default values for the current
output, select
Reset Config
from the
Output Menu
. If you select this command, custom
configurations are not restored the next time you power up the ImagePRO-II.
With the 3D/Dual Channel mezzanine installed and the system mode set to
Dual2K
, the
Out Reset Config Submenu
appears. This submenu lets you restore the output
configurations on a per-channel basis. Every output mapped to the selected channel is
restored to its default settings.
tçêâáåÖ=ïáíÜ=qÉëí=m~ííÉêåë
As you configure outputs, you can set up test patterns. You can send one test pattern to all
outputs simultaneously in Standard system mode.
Test patterns appear within the output’s Area of Interest (AOI). If the output image uses the
default AOI, the test pattern is displayed in the default active area. If you set up a custom
AOI for the output, the test pattern appears within that AOI. For more information, refer to
the
You can also set up raster boxes for both the AOI and the output active area. The following
illustration shows the
Test Pattern Menu
in the standard ImagePRO-II. Access this menu
by pressing the front-panel
TEST PAT
button.
Figure 4-50.
Test Pattern Menu
If you have the 3D/Dual Channel option installed, you can assign a test pattern to one or
both channels; the test pattern appears on any output mapped to the channel. The
following illustration shows the
Test Pattern Menu
in dual-channel mode.
Figure 4-51.
Test Pattern Menu in Dual-Channel Mode
TEST PATTERN
> Type
Off
Raster Box
Off
Diag Motion
Off
AOI Raster Box
Off
TEST PATTERN
> Channel
All
AOI Type
Off
AOI Raster Box
Off
AOI Diag Motion
Off
Out Raster Box
Off