Barco ImagePRO-II Jr, Дополнение к руководству пользователя, Страница: 59 / 166

44 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Inputs
^ÇàìëíáåÖ=qáãáåÖ=m~ê~ãÉíÉêë
The ImagePRO-II supports adjusting the positioning of the input signal’s active area. There
are two timing adjustment menus:
1:1 Timing Adjust and Edge Timing Adjust .
The 1:1 Timing Adjust Submenu displays the timing information of the input signal,
shown in the following illustration. Timing parameters are adjustable only when:
•
1:1 Sample is On and
•
The input signal is analog YP
b
P
r
or analog RGB
Figure 4-13. 1:1 Timing Adjust Submenu (sample)
The options are:
•
Sample Phase — Initially, the value is set to the default value of 0 .
The range is -16 to +15 .
If the Sample Phase is n/a , then either 1:1 Sample is Off , or the input is not
analog YP
b
P
r
or RGB.
•
H Total — This value is the total pixel count per line. This value cannot be
adjusted on the DVI-I or SDI connectors (Inputs 1 and 5 ).
•
H Position — Sets the offset of the start of the active area from H Sync.
•
H Active — Sets the size of the active area.
•
V Total — Displays the total line count per frame. This value cannot be changed
for any input.
•
V Position — Sets the offset of the start of the active area from V Sync.
•
V Active — Sets the size of the active area.
When 1:1 Sample is Off , the Timing Adjust Submenu changes to the Edge Timing
Adjust Submenu . For more information, refer to the Adjusting Edge Timings section on
this page.
^ÇàìëíáåÖ=bÇÖÉ=qáãáåÖë
When the 1:1 Sample option is Off , the Edge Timing Adjust Submenu is available in
place of the Timing Adjust Submenu .
1:1 TIMING ADJUST
> Sample Phase
n/a
H Total 1698
H Position 370
H Active 1280
V Total 1056
V Position 31
V Active 1024