Barbeques Galore EDV27-BQ, Инструкция по использованию и уходу

Страница: 8 / 38

7
LP GAS HOOK UP (TYPE 1 OR QCC1
REGULATOR):
Grills orificed for use with LP gas come equipped
with a high capacity hose/regulator assembly for
connection to a standard 20 lb. LP cylinder
(Type 1). The LP tank is not included.
Connection:
1/2" NPT male with a 3/8" Flare
adapter (included). LP Hose with a quick
disconnect and fittings are included.
Operating pressure:
10.0" W.C.
To connect the LP regulator/hose assembly to the
tank/valve assembly, first make sure the main valve
on the tank is completely closed. Although the
flow of gas is stopped when the Type 1 system is
disconnected as part of of its safety feature, you
should always turn the LP tank main valve (Fig.02)
off after each use and during transport of the tank
or unit. Insert the regulator inlet into the tank valve
and turn to the black coupler clockwise until the
coupler tightens up.
Do not overtighten the
coupler. Turn the main tank valve on and turn the
burner control valves on the unit to the “HI”
position for about 20 seconds to allow the air in
the system to purge before attempting to light the
burners.
To disconnect the coupler, first make sure the main
tank valve is turned off. Grasp the coupler and
turn counter clockwise. The inlet will then
disengage, remove the inlet from the tank valve
opening if it has not already done so when it
Bottom of unit
Threading Compound
must be resistant to
LP gas
Type 1 Regulator
Main Valve
Adapter 1/2 NPT to
3/8 flare fitting
Do not put threading
compound on these
threads
LP Regulator hose
assemby 10 W.C.
Installation must conform with local
codes or with the National Fuel Gas
Code ANSI Z223.1
Type 1 Tank
disengaged. Your local LP filling station should be
equipped with the proper equipment to fill your
tank.
LP TANK REQUIREMENTS:
A dented or rusty LP tank may be hazardous and
should be checked by your LP supplier. Never use
a cylinder with a damaged valve. Always check for
leaks after every LP tank change. The LP gas
cylinder must be constructed and marked in
accordance with the specifications for LP gas
cylinders of the U.S. Department of Transportation
(DOT) and designed for use with a Type 1 system
only. Do not change the regulator/hose assembly
from that supplied with the unit or attempt to use a
Type 1 equipped regulator/hose assembly with a
standard 510 POL tank/valve assembly. The
cylinder must be provided with a shut-off valve
terminating in an LP gas supply cylinder valve
outlet specified, as applicable, for connection
Type 1. If the appliance is stored indoors the
cylinder must be disconnected and removed from
the appliance. Cylinders must be stored outdoors
in a well-ventilated area out of the reach of
children.
Note: When a LP unit is directly attached
into a LP house system, the step
down regulator
MUST be used to
reduce the supply pressure to a max.
14” W.C. and min. 11” W.C. to the
grill regulator.
FIG.02
LP Gas
Gas Requirements