TrilliumSeries™ Adiabatic
Cooler - TRF Operation & Maintenance Manual
–
Warnings and Cautions
Page | 9
3. Warnings and Cautions
Safety Precautions
•
: Rotating equipment will cause severe personal injury or death to persons who come in contact.
Adequate safeguards (including the use of protective enclosures where necessary) should be taken with this equipment
both to safeguard the public from injury and to prevent damage to the equipment, its associated system, and the
premises.
•
: Risk of electrocution which will cause severe personal injury or death. Use appropriate lockout
procedures. Do not perform any service on or near the unit without first ensuring the unit is de-energized.
•
: Rotating equipment. Risk of serious injury or death. Never step on fan guard grill or subject the
guard grill to load. Do not place any objects on the fan guard grill.
•
:
The TrilliumSeries™ Adiabatic Cooler controls are set up to periodically flush and drain the water
system, thereby eliminating the need for water treatment. However, there may be unusual circumstances where chemicals
or biological contaminants could be introduced into the recirculating water system, that could be harmful if inhaled or
ingested. Wear appropriate respiratory protection, when exposed to the discharge air stream or to the mists produced by
cleaning activities associated with the recirculating water system or adiabatic pre-cooler pads.
•
:
Do not walk on
the top horizontal surface of the unit. It is not intended to be used as a walking
surface or working platform. Risk of falling through the surface, resulting in physical injury or equipment damage.
•
: Risk of electric shock. Live terminals and connections even with device switched off. Wait five
minutes after disconnecting the voltage at all poles before opening the fan and motor assembly.
•
: Transporting the fan. Injuries from tipping or slipping. Wear safety shoes and cut-resistant safety
gloves. The fan is only to be transported in its original packaging. The fan is to be transported lying flat, i.e., the motor axis
must be vertical. Secure the fan(s) e.g., with a lashing strip to stop anything from slipping or tipping.
•
:
High temperature on fan motor electronics housing. Risk of burns. Ensure sufficient protection
against accidental contact.
•
: Battery located in control panel PLC. Risk of explosion resulting in minor or moderate injury or
damage to property. Do not recharge or open the battery.
