Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 232 / 296

232
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
Set Length 1 This feature specifies one of the barcode lengths for Length Control. Length 1 is the minimum
label length if in Variable Length Mode, or the first fixed length if in Fixed Length Mode. Length
includes the barcode’s data characters only.
The number of characters that can be set varies, depending on the symbology. Reference the
page for your selected symbology to see specific variables.
1 Determine the desired character length (varies depending on symbology). Pad the number
with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2 Go to the Set Length page for your selected symbology and scan the ENTER/EXIT PRO-
GRAMMING MODE barcode to enter Programming Mode.
3 Scan the barcode to SELECT LENGTH 1 SETTING for your selected symbology.
4 Scan the appropriate two digits from the keypad in Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad. , that repre-
sent the length setting which was determined in the steps above. You will hear a two-beep
indication after the last character.
5 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Prog Mode.
Set Length 2 This feature allows you to set one of the barcode lengths for the specified symbology. Length 2 is
the maximum label length if in
Variable Length: For variable length decoding, a minimum and
maximum length may be set. on page 231 Mode, or the second fixed length if in Fixed Length:
For fixed length decoding, two different lengths may be set. on page 231 Mode. See the page for
the specific symbology for parameters.
The length that can be set varies depending on the symbology. A setting of 0 specifies to ignore
this length (only one fixed length).
Follow these instructions to set this feature:
1 Determine the desired character length (from 1 to 50 — or 0 to ignore this length). Pad the
number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
2 Go to the Set Length page for your selected symbology and scan the ENTER/EXIT PRO-
GRAMMING MODE barcode to enter Programming Mode.
3 Scan the barcode to SELECT LENGTH 2 SETTING for your selected symbology.
4 Scan the appropriate two digits from the keypad in Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad. that repre-
sent the length setting which was determined in the steps above. You will hear a two-beep
indication after the last character.
5 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure.
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
If you make a mistake, before the last character scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.