Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 176 / 296

176
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Plessey Set Length 2
This feature specifies one of the barcode lengths for Plessey Length Control on page 174 . Length
2 is the maximum label length if in Variable Length: For variable length decoding, a minimum and
maximum length may be set. on page 231 Mode, or the second fixed length if in Fixed Length:
For fixed length decoding, two different lengths may be set. on page 231 Mode. Length includes
the barcode’s check, data, and full-ASCII shift characters. The length does not include start/stop
characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table Plessey Length 2 Setting Examples provides examples for setting Length 2. See page 232
for detailed instructions on setting this feature.
Plessey Length 2
Setting
Examples
STEP ACTION EXAMPLES
1 Desired Setting
00 (Ignore
This Length)
07 Characters 15 Characters 50 Characters
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT PLESSEY LENGTH 2 SETTING
4
Scan Two
Characters From
Appendix 18, Use
the barcodes in
this appendix to
enter numbers as
you would select
digits/characters
from a keypad.
‘0’ and ‘0’ ‘0’ and ‘7’ ‘1’ and ‘5’ ‘5’ AND ‘0’
5 Scan ENTER/EXIT PROGRAMMING MODE
Select Plessey Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CPLL2
~
DEFAULT
50 = Length 2 is 50 Characters