Balluff BVS HS-Q Series, Руководство по эксплуатации

Страница: 225 / 296

225
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.1.2 RS-232/USB
COM
Parameters
Intercharacter
Delay This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in 10ms
increments. A setting of zero specifies no delay.
To set the delay:
1 Determine the desired setting in milliseconds.
2 Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3 Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode.
4 Go to page 38 and scan the barcode: SELECT INTERCHARACTER DELAY SETTING.
5 Scan the appropriate two digits from the keypad in Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad. , that repre-
sent the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit.
This completes the procedure. See Table Intercharacter Delay Setting Examples for some exam-
ples of how to set this feature.
Intercharacter
Delay Setting
Examples
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
STEP ACTION EXAMPLES
1 Desired Setting 50ms 150ms 600ms 850ms
2
Divide by 10 (pad
with leading zeroes
to yield two-digits)
05 15 60 85
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT INTERCHARACTER DELAY SETTING
5
Scan Two
Characters From
Appendix 18, Use
the barcodes in this
appendix to enter
numbers as you
would select digits/
characters from a
keypad.
‘0’ and ‘5’ ‘5’ and ‘0’ ‘6’ and ‘0’ ‘8’ and ‘5’
6 Scan ENTER/EXIT PROGRAMMING MODE