BA-440 DualBeam Barcode Reader Quickstart Guide Ver 5
14. Install and seal the reader Hood
Set the Hood in place over the top of the BA-440 decoder assembly so that the six studs pass into the six holes on the baseplate. The front
window of the Hood goes by the gold polygon as shown. Secure the Hood using the six 11/32” flanged nuts from the hardware bag. The
Hood must be secured using all 6 flanged nuts for a good seal.
IMPORTANT: Thread all 6 nuts finger tight first, then tighten only 1/4 to 1/2 turn more on each nut.
CAUTION: The seal on the reader Hood and hardware may be damaged if nuts are overtightened.
To prevent unauthorized access a padlock (not included) may be placed through lock tab at the rear of the BA-440.
Bottom View
Lock Tab at
Rear of Baseplate
Thread all six flanged nuts
finger tight first; then tighten
only 1/4 to 1/2 turn more to
secure Hood in place
Assembly complete.
Contact BAI at 800-528-9167 with
any questions.
