B+B SmartWorx V3, Руководство по настройке

Страница: 36 / 112

4. CONFIGURATION
Continued from previous page
Item Description
Switch to backup SIM card when
binary input is active switch to
default SIM card when binary in-
put isn’t active This parameter enables switching to secondary SIM
card or secondary APN of the SIM card, when binary
input ‘bin0’ is active. If binary input isn’t active, this
parameter enables switching back to default SIM card.
Switch to default SIM card after
timeout This parameter defines the method, how the router will
try to switch back to default SIM card or default APN.
Table 21: Switch between SIM card configurations
The following parameters define the time after which the router attempts to go back to the
default SIM card or APN.
Item Description
Initial timeout The first attempt to switch back to the primary SIM card or APN
shall be made for the time defined in the parameter Initial Time-
out, range of this parameter is from 1 to 10000 minutes.
Subsequent Timeout In an unsuccessful attempt to switch to default SIM card, the
router on the second attempt to try for the time defined in the
parameter Subsequent Timeout, range is from 1 to 10000 min.
Additive constants Any further attempt to switch back to the primary SIM card or APN
shall be made in time computed as the sum of the previous time
trial and time defined in the parameter Additive constants range
is 1-10000 minutes.
Table 22: Switch between SIM card configurations
Example :
If parameter Switch to default SIM card after timeout is checked and parameters are set as
follows: Initial Timeout – 60 min, Subsequent Timeout 30 min and Additive Timeout – 20 min,
the first attempt to switch the primary SIM card or APN shall be carried out after 60 minutes.
Switched to a failed second attempt made after 30 minutes. Third after 50 minutes (30+20).
Fourth after 70 minutes (30+20+20).
4.2.6 PPPoE Bridge Mode Configuration
If the
Enable PPPoE bridge mode
option selected, it activate the PPPoE bridge protocol
PPPoE (point-to-point over ethernet) is a network protocol for encapsulating Point-to-Point
Protocol (PPP) frames inside Ethernet frames. Allows you to create a PPPoE connection from
the device behind router. For example from PC which is connected to ETH port router. The IP
address of the SIM card will be alloted to PC.
The changes in settings will apply after pressing the Apply button.
27