B+B SmartWorx V3, Руководство по настройке

Страница: 107 / 112

7. CONFIGURATION IN TYP. SITUATIONS
Backup Routes
configuration
Finally configure the priorities of the backup routes. The
eth1 wired connection has the highest priority in this situation. In case of failure, the second
priority has WiFi wlan0 network interface, and then the mobile connection – usb0 network
interface. See fig. 85 for corresponding settings of the
Backup Routes item. System of
backup routes has to be activated by checking the Enable backup routes switching item. Then
enable backup routes switching at every backup route used and set up the priorities. Click the
Apply button to confirm the changes. For detailed configuration see chapter 4.6.
Figure 85: Backed up access to the Internet – Backup Routes configuration
The router configured this way now serves to computers in LAN for backed up access
to the Internet. You can verify the configured network interfaces in the Status section in the
Network
item. There you should see active network interfaces eth0 (connection to LAN), eth1
(wired connection to the Internet), wlan0 (WiFi connection to the Internet) and usb0 (mobile
connection to the Internet). IP adresses and other data are included. At the bottom you can
see the
Route Table
and corresponding changes of it when e.g. wired connection fails or cable
disconnected (default route changes to wlan0). And the same – if WiFi is not available, the
mobile connection will be used.
Backup routes are working even if not activated in the
Backup Routes
item, but with implicit
priorities of network interfaces set as factory default. These priorities are different from the
ones desired in this situation, see chapter 4.6.
98