AXIOMTEK STX88810VEA, Руководство пользователя

Страница: 19 / 78

STX88810 STX Evaluation Platform Module Series User’s Manual
Installation
11
C h a p t e r 3
Installation
This chapter describes the hardware installation procedures on the
STB86600
STX Evaluation Platform Base Board
. The following is a list of
typical peripherals required to build a minimum system:
„ Power supply and passive STX Module
„
IBM ™ PC/AT keyboard
„
Display monitor
„
Floppy or hard disk with MS-DOS or Flash Disk emulator
3.1 Ultra DMA/66/100 Drive Installation
To accommodate the fast transfer rate of Ultra DMA/66/100, an 80-
conductor cable is necessary when installing Ultra DMA/66 drives.
The
STX88810 Series
, on this aspect, can support a total of 4 Ultra
DMA/66/100 drives (IDE2 from AXIOMTEK 41Pin connector). It is
through the Primary IDE Connectorand Secondary IDE Connector
where the cables are connected. The diagram below illustrates the
proper installation procedure, including color coding of connectors, of
the 80-conductor cable.
Red stripe
represents pin 1
of cable
Grey ATAS TM
for Slave Drive
Black ATAS TM
for Master Drive
80-pin Ultra DMA/66 cable
Blue ATAS TM for
system board's
40-pin IDE
connector
ATA/66/100
Cable with
80 conductors
ATA/33
Cable with
40 conductors