TECHNICAL
APPENDIX
| TECHNICAL APPENDIX
16 TECHNICAL APPENDIX
The following provides all the technical explanations, the connection pinouts to and from the Genius D device. Always
refer to this technical appendix for the connections and the connection procedures. Should you discover inconsistencies
between the documentation below and the hardware device, please contact Axel Technology at the numbers and emails
provided at the end of this manual. Our technical and support department will be happy to help and assist you to the best
of our ability!
16.1 APPENDIX A - BALANCED AUDIO AND PINOUT CONNECTION
Connection diagram Balanced Audio on Balanced
XLR
for
Analog audio
Input
and
Output
(Left+Right) and
Input
and
Output
AES/EBU Digital Audio.
16.2 APPENDIX B - SERIAL DATA AND PINOUT CONNECTION
PORT 1
PORT PC
2
Tx
2
Tx
3
Rx
3
Rx
4
DTR
4
/
5
GND
5
GND
Connection to the pc requires a standard Pin-Pin serial cable i.e., not CROSSED. For correct connection, the cable
length should not exceed 20m. Ports 2 and 3 only take the Tx, Rx and GND for connection to the PC, while port 1 also
supports the DTR (Data Terminal Ready) used for connection with a modem. The connection speed of the port must
coincide with the port speed both of the Genius D and that of the serial port of the PC.
2
2
3
3
4
4
5
5
RS 232 Male
RS 232 Female
Содержание GENIUS D
