DETAIL
OF AUDIO CHANGEOVER REMOTER
| DETAIL OF AUDIO CHANGEOVER REMOTER
The photo below shows the protocol of the DTMF commands; to open this assistance click the "
?"
key
.
The format of the string is
AAA-OC-RR
.
Where AAA is the destination of the command that can be towards a single Genius D or a group of Genius D or to all the
Genius D inserted in an audio chain (see Command String Help on the next page)
OC means the OUTPUT and COMMAND, the command can be sent to the Analog output (1) or directly to the GPO via
the (3). C are meant as the COMMANDS relating to the output GPO
Example 1:
In the example above, that is the tutorial included within the control software both of Fox and of Genius D, there is an
example, the command *
401206
that means:
*40 =
Command sent to all the Fox / Genius D whose last two digits are 40 in their ID Address.
1 =
Action to be carried out on the ANALOG OUTPUT (1)
2 =
command to be carried out on the variable shown above, i.e. on the analog output, thus C=2 as a result input -B is
sent to the Analog output.
06 =
06 minutes multiplied by x5 stable minutes = 30 minutes, i.e. the above requested command is run for 30 minutes,
at the end of which the command is terminated and the initial condition returns, which is the same as before execution of
the command
Содержание GENIUS D
