Avocent MergePoint Unity, Инструкция по установке и эксплуатации

Страница: 42 / 97

3. Fill out the user information on the screen, then click Save .
SNMP Settings
SNMP is a protocol used to communicate management information between network
management applications and MergePoint Unity switches. Other SNMP managers can
communicate with your MergePoint Unity switches by accessing MIB-II and the public portion
of the enterprise MIB. When you open the SNMP screen, the OBWI will retrieve the SNMP
parameters from the unit.
From the SNMP screen, you can enter system information and community strings. You may also
designate which stations can manage the MergePoint Unity switch as well as receive SNMP
traps from the switch. If you select
Enable SNMP , the unit will respond to SNMP requests over
UDP port 161.
To configure general SNMP settings:
1. Select Unit View - Appliance - Appliance Settings - SNMP - SNMP Settings to open the
SNMP screen.
2. Click to enable the Enable SNMP checkbox to allow the MergePoint Unity switch to
respond to SNMP requests over UDP port 161.
3. Enter the system’s fully qualified domain name in the Name field, as well as a node contact
person in the Contact field.
4. Enter the Read, Write and Trap community names. These specify the community strings
that must be used in SNMP actions. The Read and Write strings only apply to SNMP over
UDP port 161 and act as passwords that protect access to the MergePoint Unity switch.
The values can be up to 64 characters in length. These fields may not be left blank.
5. Type the address of up to four management workstations that are allowed to manage this
MergePoint Unity switch in the Allowable Managers fields. Alternatively, you may leave
these fields blank to allow any station to manage the Remote Console Switch.
6. Click Save .
Event Settings
An event is a notification sent by the MergePoint Unity switch to a management station
indicating that something has occurred that may require further attention.
To enable individual events:
1. Select Unit View - Appliance - Appliance Settings - Auditing - Events to open the Events
screen.
34 MergePoint Unity® Switch Installer/User Guide