Avocent MergePoint Unity, Инструкция по установке и эксплуатации

Страница: 20 / 97

Configuring the MergePoint Unity Switch
Once all physical connections have been made, you will need to configure the switch for use in
the overall switching system. This can be accomplished in two ways.
To configure the MergePoint Unity switch using the DSView 3 software:
See the DSView 3 Installer/User Guide for detailed instructions.
To configure the MergePoint Unity switch using the local UI:
See Network Settings on page 27 for detailed instructions on using the local UI to configure
initial network setup.
Setting up the built-in web server
You can access the MergePoint Unity switch via an embedded web server that handles most
day-to-day switching tasks. Before using the web server to access the switch, first specify an IP
address through the local port on the back panel of the switch or local UI. See Chapter 3 for
detailed instructions on using the user interface for switching.
Connecting to the OBWI through a firewall
For MergePoint Unity switch installations that use the OBWI for access, four ports must be
opened in a firewall if outside access is desired.
TCP Port
Number
Function
22 Used for SSH for serial sessions to an MPUIQ-SRL module
23 Used for Telnet (when Telnet is enabled)
80
Used for the initial downloading of the Avocent Video Viewer (for downloading the Java
applet)
443
Used by the web browser interface for managing the MergePoint Unity switch and launching
KVM sessions
2068
Transmission of KVM session data (mouse & keyboard) or transmission of video on
MergePoint Unity switches
Table 2.2: TCP Ports and Functions for the MergePoint Unity Switch OBWI
In a typical configuration, as shown in Figure 2.2, the user’s computer is located outside of the
firewall, and the MergePoint Unity switch resides inside the firewall.
12 MergePoint Unity® Switch Installer/User Guide