AVL Looms Dobby V Series, Руководство пользователя

Страница: 80 / 110

V-Series Dobby Loom User’s Manual Weaving Instructions
Warping The Sectional Beam Page | 76
7) Remove the heddle retainer.
8) Pull apart the top two twist ties and insert the top of the harness
(which is up) into the space created. Pull apart the bottom two twist
ties and insert the bottom of the harness into the space created.
9) Reattach the heddle retainer.
Figure 60 - Tension Box
Positioning The Tension Box
First bring the Front Beam to the back of the loom and mount it in the two
notches located on the Mid-Rear Horizontals (#6, #6A). Next, flip the
Separation Beam at the back of the loom, exposing the side with the groove
in it. If you have two Warp Beams and have mounted the second Separation
Bar, remove it for this process.
Mount the Tension Box in the groove, with the Counter facing into the loom.
The Tension Box is fastened to the Separation Beam with a small cross piece
and wing nuts. This will stabilize the Tension Box and allow it to travel
smoothly from one section to another. The wing nuts can be released for the
Tension Box to move easily from side to side. Each time the Tension Box is
moved and centered properly for a particular section, the wing nuts must be
tightened again.