AVL Looms Dobby V Series, Руководство пользователя

Страница: 36 / 110

V-Series Dobby Loom User’s Manual Loom Assembly
Install Harnesses Page | 32
6) Without removing the plastic wrapping, insert the Flat Head
Machine Screws into the four mounting holes. You will need to
punch holes in the plastic. Once all 4 screws are in place remove
the plastic and add the square nuts. Tighten securely.
7) Remove the top shelf held between #21 and #22 by pulling the
retainer pin (located at the back of the rear Harness Pulley Support)
and sliding the board out to one side. Set the shelf aside while the
harnesses are mounted into place.
Figure 26 - Shelf Retainer Pin
Install The Dobby Back (For Your Compu-Dobby)
Your Compu-Dobby is made of two parts:
1. The Dobby Back –This is the mechanical side of the Dobby; the flat
board to which are mounted the Dobby Cables, Slide Rods, and Slide
Plate.
2. The Compu-Dobby – This is the electrical side of the Dobby; containing
the solenoids and processor that enable the commands from your
computer to fire the correct solenoids. This is mounted to the Dobby
Back for safe shipment, in a very special box. Please, if at all possible,
retain this box, in the event the Compu-Dobby must be returned to
AVL Looms for warranty work or servicing.
1) Remove the Compu-Dobby from the Dobby Back, by removing the
four black thumbscrews at the sides. Replace the thumbscrews in
their holes in the Compu-Dobby and store the Compu-Dobby in the
shipping box for the time being. The Dobby Cables on the Dobby
Back are now exposed. Please exercise caution to avoid creating
bends in these Dobby Cables.