AVL Looms Dobby V Series, Руководство пользователя

Страница: 46 / 110

V-Series Dobby Loom User’s Manual Loom Assembly
Install Beater Page | 42
17) Place a level in the center of the race and adjust the height of each
side, using the black adjustment knob at the metal plate on the
Beater Support. These enable you to raise or lower the race on
either side, to ensure the race is level.
18) Once the race is level, hold the Beater Top at its center and push
the Beater all the way back, to meet the Beater Bumpers. Ensure
that both sides of the Beater are touching the bumpers.
19) Check that the legs are spaced equally from the outer sides of the
loom. Adjust as needed, with slight horizontal movements to the
Beater Top. This ensures that the legs will not rub on the loom
frame.
20) Hold the Beater against the bumpers and tighten the bolts that
attach the Beater Legs to the Shuttle Race and the Beater Top to
the legs.
Note:
There are three steel pins in the Beater support that allow you to adjust the
angle of the race. Just lift the beater and replace it over another set of pins.
Be sure both sides are on matching pins.
Install the Sliding Beater
The sliding beater is optional equipment that replaces the swinging beater. If
you have chosen a sliding beater for your loom, follow the instructions in this
section to install it.
1) Locate the sliding beater assembly and bring it to your loom.
Attached to the assembly are bags with mounting hardware. In
them you will find:
Beater Mounting Blocks 4
3/8” x 3” Flat Head Machine Screws 2
3/8” x 6” Flat Head Machine Screws 2
3/8” Square Nuts 2
3/8” Nylock Nuts 2
2) Consult the following diagram to determine the proper beater
orientation. Position each block on the correct end of the Beater
Slide Rods according to its label. The large countersunk holes in
each block should be oriented to the top. Drop the longer screws
into the rear blocks, the shorter into the front.