AVL Looms Dobby V Series, Руководство пользователя

Страница: 41 / 110

V-Series Dobby Loom User’s Manual Loom Assembly
Install Harnesses Page | 37
2) First you will attach the clip to the Dobby Head. Squeeze the sides
of the berkeley clip to expose the hooked ends. You can use pliers
to squeeze the hook. Attach the Harness Cable to the correct Dobby
Cable on the Dobby Head.
Figure 30 - Berkeley Clip
3) Take the end of the cable that was not attached to the Dobby Head
and place the long end of the cable over the pulley furthest from
the Dobby and the shorter piece over the middle pulley.
Note:
Check that the cable is not twisted on itself — this will cause problems when
you are weaving.
4) Take up an assembled Harness Frame. Orient the frame so the
hooks that are set closest together are at the
TOP of the frame.
5) Hook the eyehooks at the top of the frame to the harness cable you
just installed.
6) Locate two harness springs. Fasten one of these springs to the
bottom eyehook on the right side of the harness and place the
other end over the eyehook mounted on the right side of the Spring
Support immediately below the harnesses. Repeat for the left-hand
spring.
7) Repeat these steps for each harness.
Note:
Check your work periodically; it’s easy to connect the wrong harnesses or
springs into the wrong set of eyehooks.