AVL Looms Dobby V Series, Руководство пользователя

Страница: 64 / 110

V-Series Dobby Loom User’s Manual Loom Assembly
Install The Warp Beam Page | 60
Drum. Wrap it around the Brake Drum; it will pass over the top of
the drum three times. Take care
not to cross the cable on itself.
10) When you’ve just enough cable remaining to almost reach the
brake pedal, collect the three loops of the cord into the snap hook.
Note:
Check again to make sure the cable isn’t crossed on itself.
11) Use the toggle on the tie-up to adjust the tension on the pedal. To
increase tension, pull the two ends of cord away from the toggle. To
decrease the tension, squeeze the buttons on either side of the
toggle and move it up and down on the looped ends.
Figure 53 - Brake Cable Toggle
Note:
If the cable is installed in the wrong direction the Beam will turn easily toward
the front of the loom and you will be unable to establish good tension.