EN
29
EN
28
In phase 1, panel M2 did
not reach a stop after
opening for 60s or cable
section too weak?
In phase 1, motor M1
was not detected (contact
failure, electronic card
problem?)
Review motor
connections.
In phase 1, motor M2
was not detected (contact
failure, electronic card
problem?)
Review motor
connections.
Self-learning was
interrupted by the user.
2.8 - PROGRAMMING REMOTE CONTROLS
It is possible to open both panels (gate) or a single
panel (pedestrian) by remote control.
On a remote control, it is possible to decide
which button will be used as the gate command
and which button will be used as the pedestrian
command.
2.8.1 - PROGRAMMING WITH THE CARD
Note:
It is possible to programme a remote control once,
then use the “copy” function that allows you to
programme additional remote controls without
using the electronic card, via a remote control
that has already been programmed. (This is useful
when additional remote controls are available for
programming without having to open the electronic
control box).
Programming a button for the GATE OPENING
command:
• Press “–” for 3 seconds and L1 will switch on.
• Press
OK
and L1 and L4 will turn on alternately.
• Within the next 10 seconds, press the remote
control button for memorisation.
• If the red LEDs all turn on for 1 second, this
means that memorisation is successful.
• If the red LEDs all flash 3 times, this means
that the system has waited for more than 10
seconds without receiving valid information.
Restart the programming.
Programming a button for the Pedestrian
OPENING command:
• Press “
–
” for 3 seconds and L1 will switch on.
• Press “
+
” and L1 will switch off and L2 will switch
on.
• Press
OK
and L1 and L4 will turn on alternately.
•
Within the next 10 seconds, press the
remote
control button for memorisation.
• If the red LEDs all turn on for 1 second, this
means that memorisation is successful.
• If the red LEDs all flash 3 times, this means
that the system has waited for more than 10
seconds without receiving valid information.
Restart the programming.
2.8.2 - COPY PROGRAMMING
From a remote control that has already been
memorised, you can memorise other remote
controls (“copy” function).
For each new remote control to be memorised,
follow the procedure below
• Stand near the motor.
• Press simultaneously on both buttons at the bottom
of the remote control already in the memory until
the flashing light switches on (around 6 seconds).
• Press any button on the new remote control. The
flashing light will flash 3 times and then turn off.
The new remote control is now memorised (the
buttons will have the same function as the original
remote control).
D - BEGINNING OPERATION
