Chapter 3: Setting Up D-Control
21
7
Using a 3/16-inch hex wrench, attach the rear rail to the rail
tabs on each leg from below with 1/4-inch-20 x 1/2 inch socket
head cap screws (see Figure 13), using 2 screws in each side.
Make sure to leave the screws loose enough so that the leg as-
semblies can be moved side-to-side relative to the rear rail.
8
Locate the front pan support rail, which is the smaller of the
two rails provided with the stand.
9
Position the front rail so that the edge with the V-shaped
notch points toward the left stand leg.
10
Lift the front rail into place so that the rail rests on the front
rail tabs of the stand legs. The holes on the ends of the rail
should line up with the slots in the front rail tabs on each leg.
11
Using a 3/16-inch hex wrench, attach the front rail to the
rail tabs on each leg from below with 1/4-inch-20 x 1/2 inch
socket head cap screws, using 2 screws in each side. Make sure
to leave the screws loose enough so that the leg assemblies can
be moved side-to-side relative to the front rail.
With the rear crossbar, rear support rail and front support rail
in place (see Figure 15), you are now ready to install the
D-Control units on the stand.
Figure 13. Attaching support rail from below
Figure 14. V-shaped notch in front pan support rail
Notch indicating left side of front pan support rail
Figure 15. Front and rear support rails in place on left stand leg
Содержание 9320-65044-00
