Avid Technology 9320-65044-00, Руководство пользователя

Страница: 153 / 186

Chapter 12: Assigning Inserts, Sends and I/O with the Assign Matrix 147
Closing the Assign Matrix
To close the Assign Matrix, do any of the following:

Press the bottom encoder Select switch (when labeled
“Exit”) in the Assign Matrix Navigation Area. This exits the
Assign Matrix even when the Matrix is locked.

Hold Control (Windows) or Command (Mac) and press the
bottom encoder Select switch (when labeled “Back”) in the As-
sign Matrix Navigation Area. This exits the Assign Matrix even
when the Matrix is locked.

Press the flashing Escape switch. This works only when the
Assign Matrix is not locked.
Assigning I/O Paths
To assign an I/O path:
1
Press and hold the Sends switch on the channel where you
want to assign the path. I/O paths are displayed on the channel
encoders.
2
Press the encoder Select switch for the I/O path you want to
assign. The Assign Matrix opens, with the current path indi-
cated by yellow text and a lit Select switch.
3
If necessary, use the switches in the Assign Matrix Naviga-
tion area to locate the I/O path you want to assign.
4
Press the encoder Select switch for the I/O path you want to
assign.
To assign multiple output paths (audio or MIDI):
1
Follow the above procedures to use the Assign Matrix to as-
sign or change an output path assignment.
2
If you want to make multiple assignments, enable Assign
Lock mode by pressing the encoder Select switch labeled
“Lock” in the Assign Matrix Navigation area.
3
In the Assign Matrix Navigation area, press the B/M/P switch
labeled “+” (below the “Lock” encoder) to latch output assign-
ments.
4
If necessary, use the switches in the Assign Matrix Naviga-
tion area to locate the output path you want to assign.
5
Press the encoder Select switches for the additional output
paths you want to assign.
To remove an I/O path:
1
Press and hold the Sends switch on the channel where you
want to remove the path. I/O paths are displayed on the chan-
nel encoders.
2
Press the encoder Select switch for the I/O path you want to
remove. The Assign Matrix opens, with the current path indi-
cated by yellow text and a lit Select switch.
3
In the Assign Matrix Navigation area, press the encoder Se-
lect switch labeled “Back” on the bottom encoder until you
reach the top level of I/O paths, then press the encoder Select
switch that corresponds to “--” (No I/O) in the Assign Matrix
Select area.