Avery Weigh-Tronix E1070, Руководство по обслуживанию

Страница: 90 / 164

90 E1070 Service Manual
3 Using the Menus
28. Press UNITS or TARE to toggle between on and oFF . If the indicator is being
connected to a SensorComm junction box and you want to send an email
when a SensorComm error occurs, select
on . Otherwise select oFF . Press
either the PRINT or ENTER key to accept your selection…
S-Com is displayed.
29. Press the UNITS key…
gHoSt is displayed.
30. Press the PRINT key…
on or oFF is displayed.
31. If the indicator is being connected to a SensorComm junction box and
Ghosting is enabled and you want to send and email when a cell is ghosted,
select
on . Otherwise select oFF . Toggle to your choice and press either the
PRINT or ENTER key to accept your selection…
gHoSt is displayed.
32. Press the SELECT key, then the UNITS key….
ProtcL is displayed.
33. Press the PRINT key…
SMA , Enq or rdiSP is displayed.
34. Scroll through the choices using the TARE and UNITS keys. When the
desired choice is shown, press the PRINT key to select it.
SMA The SMA protocol over the Ethernet connection.
This is the exact same protocol used on the serial
ports. See the Service-Serial section of this manual
for details.
Enq If Enq is chosen you will be prompted to key in a
polling character. This can be any value from 0 to
255. Example: if the desired polling character is a
carriage return, enter 13 for the polling character.
After the polling character is keyed in, press the
ENTER key and the display will return to ProtcL .
When the polling character is received on the
Ethernet connection, the indicator will act as if the
PRINT key has been pressed (all of the formats-to-
print will be sent out of the configured port). If you
want the print format(s) to be sent back on the
Ethernet connection, the print formats must be
configured for tcpip1 (net1) or tcpip2 (net2). See the
Service-App and Service-Serial sections of this
manual for details on setting up the print formats.