Avery Weigh-Tronix E1070, Руководство по обслуживанию

Страница: 59 / 164

E1070 Service Manual 59
3.4 Service Menu
Table 3: SMA protocol
Command Sent to Indicator Result
<LF>W<CR> Weight returned if no motion. Dashes displayed if motion on scale.
<LF>P<CR> Weight returned if no motion. Dashes displayed if motion on scale.
<LF>Z<CR> Scale zeros itself if no motion. Dashes displayed if motion on scale.
<LF>T<CR> Scale tares itself and returns G or N weight if no motion. Dashes displayed if motion on scale.
<LF>T<xxxxxx.xxx><CR> Scale attempts to take the <xxxxxx.xxx> data as the tare weight and returns G or N weight if no
motion. Dashes displayed if motion on scale.
<LF>M<CR> Returns the tare weight if no motion. Dashes displayed if motion on scale.
<LF>C<CR> Clears the tare weight if no motion. Dashes displayed if motion on scale.
<LF>U<uuu><CR> Sets the unit of measure label to uuu Example: lb_ ( _ =space) Works for lb or kg only, not
custom units
<LF>D<CR> Runs scale diagnostics and sends diagnostic message
<LF>A<CR> Sends the SMA compliance level. See note at left.
<LF>B<CR> 1st B sent returns manufacturer
2nd B sent returns model software #
3rd B sent returns the software revision level
4th B sends an END
5th or more sends a ?
<LF>U<CR> Toggles the units of measure if no motion. Dashes displayed if motion on scale.
<LF>I<CR> Sends the SMA compliance level as SMA:compliance level / revision level
<LF>N<CR> 1st N sends the scale type; S or C .
TYP:S = scale, TYP:C = Classifier
2nd N sends CAP:uuu:c..c:n:d where
uuu = unit of measure
c..c = full capacity of this range. If multi-interval is not enabled, this is the scale capacity.
n = Least significant count-by digit
d = decimal point position:
0 = none
1 = XXXX.X
2 = XXX.XX
3 = XX.XXX…etc.
3rd N sends the following if multi-interval is enabled: the same info as the 2nd N except for the
upper range of the multi-interval.
3rd N sends the following if the multi-interval is disabled: List of the SMA level 2 commands that
are implemented:
CMD:PTMCU
Last valid N sends END
Subsequent N commands will return a ‘?’ response.
ESC This reboots the indicator
<LF>XP<num><CR> Request a print format to be printed, 0-10
<LF>XT<cutoff><xxxx.xx><CR>
Set a cutoff/trip weight. Attempts the take <xxxx.xx> as the weight for cutoff #<cutoff>. The indicator will respond with:
<LF>XT<cutoff><xxxx.xx>Set<CR> if the cutoff weight was accepted or <LF>XTFail<CR> if the
cutoff weight could not be set to the value specified. Cutoff =1-3. Weight limited to scale cap.