Avery Weigh-Tronix E1070, Руководство по обслуживанию

Страница: 60 / 164

60 E1070 Service Manual
3 Using the Menus
<LF>XT<cutoff><CR>
Request a cutoff/trip weight. The indicator will respond with: <LF>XT<cutoff><xxxx.xx><CR> where <xxxx.xx> is the weight
for cutoff number <cutoff>.
or
<LF>XTError<CR> if the cutoff number specified is invalid. Cutoff =1-3. Weight limited to scale
cap.
<LF>XB<CR> This command can be sent over a serial or sockets connection if it is configured for SMA mode.
This returns a list of keys that have been pressed since the list was last cleared. Each key
pressed is represented by a letter, shown below:
TARE = T
SELECT = S
ZERO = Z
PRINT = P
UNITS = U
F1 = F
CLEAR = C
MODE = M
EXCAPE = X
ENTER = E
POWER = O
DECIMAL = D
0-9 = 0-9
Example: <LF>XBTSF<CR>
This response shows that the Tare, Select and F1 keys have been pressed since the last time
the list was cleared.
<LF>XBC<CR> This will clear the list of key presses from memory.
Response: <LF>XBCDone<CR>
<LF>XC<channel><CR>
Set the PLU channel. Attempts to set the PLU channel to <channel>. The indicator responds with:
<LF>XC<channel>Set<CR> if the channel number was valid.
Or
<LF>XCFail<CR> if the channel number was invalid. Valid channel numbers are 0-10.
<LF>XC<CR>
Request the PLU current channel. The indicator will respond with: <LF>XC<channel><CR>
<LF>XI<id><CR>
Set the ID number of
current PLU channel. The indicator will respond with:<LF>XI<id>Set<CR>
<LF>XI<CR> Request the id
number of the current PLU channel. The indicator will respond with: <LF>XI<id><CR>
<LF>XK<lower limit>,<upper
limit><CR> Set the checkweigher
lower and upper limit. The indicator will respond with:
<LF>XK<lower limit>,<upper limit>Set<CR> if the limits where set successfully.
Or
<LF>XKFail<CR> if the limit values were invalid.
<LF>XK<CR> Request the
checkweigher lower and upper limit
values. The indicator will respond with:
<LF>XK<lower limit>,<upper limit><CR>
<LF>XE<pcwt><CR>Set the piece
weight for the Counting application. The indicator will respond with:
<LF>XE<pcwt>Set<CR>
<LF>XE<CR> Request the piece
weight for the Counting application. The indicator will respond with:
<LF>XE<pcwt><CR>
Table 3: SMA protocol
Command Sent to Indicator Result