Avaya one-X Deskphone Edition, Руководство по установке и обслуживанию

Страница: 61 / 74

Scenarios for the Restart Process
Issue 2 December 2007 61
message. In addition, a progress bar consisting of an unfilled black rectangle displays,
centered on an Application Line below the logo image, as shown below.
The rectangle fills from left-to-right as storage proceeds, with the filled percentage of the
rectangle being approximately the same as the percentage of the file that has been stored.
Note:
Note:
Holding down the OK button during Step 4 displays the software image filename.
5. When control is passed to the software that was just loaded, the following messages
display:
This message continues while the new boot code is being written into RAM.
!
Important:
Important:
Pressing Program at this time invokes the Craft Access entry procedure to allow
manual settings, but only if the PROCSTAT (local dialpad procedure status)
system value is “0” providing full access to local procedures. For information, see
Chapter 3: Local Administrative Options .
6. The telephone displays the speed of the Ethernet interface in Mbps, that is, 0, 10, 100, or
1000. The message
No Ethernet
displays until the software determines whether the
interface is 10 Mbps, 100 Mbps, or 1000Mbps.
Note:
Note:
The Ethernet speed indicated is the LAN interface speed for both the telephone
and any attached PC, assuming the administrator has not disabled the latter
interface by a PHY2STAT setting.
7. The IP telephone sends a request to the DHCP server and invokes the DHCP process.
The following message displays:
where s is the number of seconds that have elapsed since DHCP was invoked. The number
of elapsed seconds is incremented once per second, until DHCP successfully completes.
Starting...
Updating boot code...
DO NOT UNPLUG THE PHONE!
DHCP:
s
secs