Page 6 - Environmental requirements
Preparing for Installation
Page 6 - Preparing for Installation
Installation & Maintenance
INDeX 30
38DHB0002UKDF- Issue 4 (07/2001)
Environmental requirements
The planned location must meet the following requirements:
– Check that the area is a well ventilated area, having a temperature range of 0
°
C
to +40
°
C and a humidity range of 10% to 90% non-condensing.
– Check there are no flammable materials in the area.
– Check there is no possibility of flooding.
– Check that no other machinery or equipment needs to be moved first.
– Check that it is not an excessively dusty atmosphere.
– Check that the area is unlikely to suffer rapid changes in temperature and
humidity.
– Check for the proximity of strong magnetic fields, sources of radio frequency and
other electrical interference.
– Check there are no corrosive chemicals or gasses.
– Check there is no excessive vibration or potential of excessive vibration,
especially of the cabinet mounting surface.
Power Supply Requirements
Check the following:
–
INDeX 30 Cabinet :
An INDeX 30 requires a separate switched mains supply. This should be a 230V
(
±
10%), 50Hz single-phase mains supply rated at 10A maximum. The supplied
mains-in cable length is 3 metres. Each mains supply must provide an earth
connection
(see "
.
–
UPS Equipment :
The use of UPS's to support the INDeX 30 system during mains power
failure is highly recommended. Such equipment also provides mains
conditioning. Contact Avaya for details of preferred and tested suppliers and
models. The general requirement is for a 50 VA rated UPS.
–
Peripheral Equipment :
Check that sufficient mains supply sockets exist for any peripheral equipment
that may be connected to the INDeX 30 system.
Heat Dissipation
The following figure is for worst case heat dissipation from INDeX 30 systems. It
assumes that the system has been correctly installed.
– 50W (171BTU).