Terminal Installation
Checking Terminals - Page 29
Installation & Maintenance
Terminal Installation - Page 29
INDeX 30
38DHB0002UKDF- Issue 4 (07/2001)
Checking Terminals
It is preferable to leave connection of terminals until after installation of other INDeX
equipment and full system programming has been completed (including the setup of
directory numbers and names).
Whilst installing and checking each terminal, it may also be required to do some
basic terminal programming such as setting diverts and pickup group numbers.
Note that by INDeX terminals we mean devices manufactured and supplied as part
of the INDeX product range and not third party terminal devices.
Refer to the INDeX series 20 User Guides for setting up details.
Connecting & Checking Two-Wire Terminals
All two-wire devices should be tested according to the manufacturer's instructions
before connection to the INDeX 30 system. After checking that the device's LD/MF
settings match the socket's (
Terminal
>
Analogue control data
), connect the two-
wire device and make a test call.
Connecting & Testing INDeX Non-Display Terminals
Use the following process to connect and check INDeX terminals without displays.
To check a non-display INDeX terminal :
1. Unpack the terminal and check that all parts are present including labels and
user guides.
2. Insert the handset cord into the base. Route the cord thorough the cable
channels to come out at the side of the terminal.
3. Insert the line cord into the wall socket.
4. While holding down the
1
key, insert the line cord into the terminal's base and
then release the
1
key.
5. Press each key and check that you hear a tone.
6. Lift the handset and check that you hear dial tone. Press
SPEAKER
, you should
hear dial tone through the speaker. Replace the handset and press
ANSWER
RELEASE
.
7. Remove the line cord. Wait a few seconds and then reinsert the line cord without
holding down any keys.
8. Make a test call to another extension.