Page 22 - Logging On
Basic System Programming
Page 22 - Basic System Programming
Installation & Maintenance
INDeX 30
38DHB0002UKDF- Issue 4 (07/2001)
Using HyperTerminal
1. Connect the serial cable between your PC Port 1 and Port 1 (RH port viewed
from the front) of the INDeX 30. Only Avaya supplied serial cables should be
used otherwise damage to the INDeX or connected equipment may occur.
2. In Windows, select
Start | Run
and enter
Hypertrm.exe
3. Enter a name for the file, select Com Port 1 and, at Port Settings, select 9600
baud with flow control set to Xon/Xoff.
4. From File, select Properties and Settings. Select ANSI as the emulation.
5. Press
↵
and the
INDeX Administration
menu will appear.
Note and record the INDeX CPU serial number for future reference (required for
the issue of any future licence key).
6. Enter the
Username>
and press
↵
.
The
Password>
will appear. Enter your
programming password and press
↵
.
Remember that the INDeX 30 is case sensitive.
After three incorrect logon attempts, the INDeX 30 locks the programming
port for one hour. You can reset the system by switching the power off and
on again or you may use the other serial port.
7. If the password is OK, the resources menu is displayed; stating software version
level and language being used. Press
↵
to display the
Administration
menu.