AVANT 225, Руководство оператора, Страница: 60 / 84

Avant 220/225
60
.
Daily inspections
Do a walk-around check of the loader before each working shift. Check at least the following points and do not use
the loader if you notice problems with any of the listed items.
Check before start To check
1.
Tyre pressure

Check visually daily

Check with pressure gauge if wrong pressure is suspected, see page
25
2. Hydraulic oil level
 Check level of hydraulic oil especially after using a new attachment
that drains hydraulic oil from the loader as the hydraulic system of the
attachment fills up. Check also if a leak is detected.
3. Need for lubrication
 Make sure all joints are lubricated sufficiently, see page 62
4. Cleanliness of engine
compartment and radiators
 Keep engine area clean to prevent engine from overheating

Check and clean engine cooling areas, air intake areas and external
surfaces of engine (particularly after storage)
 Dust, hay, and dry materials on and around the engine will cause a
fire hazard
5. Oil or fuel leakages

Check the underside of the loader. Also check ground/floor surface
for signs of leakage
 Never operate if leakage is observed. Repair before use
6. General condition of the
loader
 Check for damages on metal parts or rust
 Ensure all safety decals are in place and legible
7.
Condition of the safety
frame, seat belt, lamps, and
other safety equipment
 Safety frame (ROPS) and protective roof (FOPS) must be fitted
 Safety structures must not have visible damage or deformations.
They must be replaced after any incident
 Make sure all lamps are functional and clean
8. Attachment and its locking
 Locking of attachment and locking pins on attachment coupling plate

Function of attachment, position of attachment hoses

See also the operator's manual of the attachment, see page 4
9.
Exhaust pipe and spark
arrestor (if equipped)

Check that no combustible material is in contact with exhaust pipe or
muffler
 If spark arrestor is fitted, check its condition and installation
Check after starting the
engine
10.
Drive control and steering
 Check operation of pedals and steering after start. Pedals must move
freely and not get stuck or feel stiff

Check that loader stops when not pressing the drive pedals. Do not
use the loader if braking performance is decreased or if the loader
creeps
 Allow the loader to warm up and check steering
11. Boom movements

Boom should move smoothly to all extreme positions when using
without an attachment
 If attachment is fitted, check that the boom moves smoothly within its
normal operating range

Hydraulic hoses or electric cables must not get pinched or stretched
in any position of the boom