AVANT 225, Руководство оператора, Страница: 52 / 84

Avant 220/225
52
.
Coupling the attachments
Attaching the attachment to the loader is quick and easy, but it must be done carefully. The attachment is mounted
to the loader boom by using the quick attach plate on the loader boom and the counterpart on the attachment.
If the attachment is not locked to the loader, it may detach from the loader and cause a hazardous situation. The
loader must not be driven and the boom must never be lifted when the attachment has not been locked. To
prevent hazardous situations, always follow the coupling procedure shown below. Also remember the safety
instructions shown in this manual. The attachment is mounted to the loader as follows:
DANGER
Make sure that an unlocked attachment will not move or fall over. Do not stay in the area
between the attachment and the loader. Mount the attachment only on level surface.
Never move or lift an attachment that has not been locked.
Always read also the additional instructions for coupling and using of the attachment in
the Operator's Manual of the attachment.
Step 1:

Lift the quick attach plate locking pins up and turn them backwards into the
slot so that they are locked in the upper position.

Ensure that the hydraulic hoses (and the electric harness, if applicable) are
not in the way during installation.
Step 2:

Turn the quick attach plate hydraulically to an obliquely forward position.

Drive the loader onto the attachment.

Align the upper pins of the loader’s quick coupling plate so that they are
under the corresponding brackets of the attachment.
Step 3:

Lift the boom slightly
– pull the boom control lever backward to raise the
attachment off the ground.

Turn the boom control lever left to turn the bottom section of the quick
attach plate onto the attachment.

Lock the locking pins manually.

Always check the locking of pins.