26
SecuraLift® Rhino
Installation Instructions & Owner’s Manual
If You Need a Service Call
If the opener needs service please call the dealer
who installed the garage door opener (for product
assistance contact 1300 133 944, within Australia).
BEFORE CALLING
please have the following
information ready to assist in a quick solution:
Has anything happened since the opener last
operated OK, e.g. a storm, damage to the door
etc.?
Is it easy to manually open and close the door?
What model is the opener?
Who installed the opener?
When was it installed?
1.
2.
3.
4.
5.
Fault Indicator
When a fault is detected the SERVICE LED will start to fl ash
and a number of beeps will sound to indicate that there
is a fault. The fault will be active each time an attempt is
made to operate the door.
Pressing the LIMIT SET button will reset the opener. If the
fault continues to be tripped contact an Approved Dealer
for assistance.
Troubleshooting Guide
Symptom
Possible cause
Remedy
The opener does not work from
the transmitter
Garage door in poor condition e.g.
springs may be broken
The opener does not have power
The battery in the transmitter is fl at
The opener has been put into
“Vacation Mode”
The transmitter code has not been
set
Check the door’s operation - see
monthly maintenance (Page 30)
Plug a device e.g. a lamp, into the
power point and check that it is OK
Replace the battery
Turn off “Vacation Mode” (Page
22)
See transmitter & code setting
procedure (Page 21)
The motor runs but the door does
not move
The opener is disengaged
Re-engage the opener
The transmitter range varies or is
restricted
Variations are normal depending
on conditions e.g. temperature
or external interference
The battery is fl at or faulty
Position of the transmitter in the
motor vehicle
Position of the aerial will not pick
up the radio signal
Replace the battery
Change the position
Install an external aerial kit – see
Accessories (Page 24)
The light does not work
Light module is not inserted/
connected properly
Check for correct connection
otherwise contact your dealer for
support
The door reverses for no apparent
reason
This may occur occasionally from
weather changes
The opener automatically adjusts
to compensate for changes, to
adjust the force see (Page 20)
The door opens but will not close
Auto-Close or P.E. Beams not
operating correctly
Check the installation (Page 25)
otherwise contact your dealer for
support
