Installation Instructions & Owner’s Manual
SecuraLift® Rhino
25
P.E. Beams
For
ADDITIONAL PROTECTION
Automatic Technology
STRONGLY
recommend the fi tting of P.E. Beams. In most
countries P.E. Beams are mandatory on all garage doors
fi tted with automatic openers. For a small additional outlay,
Automatic Technology recommends that P.E. Beams be
installed with the automatic opener for additional safety
and peace of mind.
Locate the P.E. Beams in a strategic location within the
doorway. It is recommended that it be positioned:
150mm above the fl oor level
as close as possible to the door opening
inside the garage
Make sure to align the beams correctly. Follow the manual
supplied with the P.E. Beams. Connect the wires to the
terminal block as per (
Fig. 41).
WARNING:
When using Auto-Close mode and
P.E. Beams, the doorway must be clear of all
obstructions and persons at all times. The location of the
beam and manner in which it is installed might not give
safety protection at all times. Check to make sure that
the height of the beam and type used give maximum
protection possible.
Electric Key Switch
An electric key switch can be connected to the opener
as an alternative to using the transmitter. The electric key
switch (
Fig. 42)
also acts as an external release mechanism
which is ideal if your garage does not have a pedestrian
entrance
To connect the switch to the opener’s terminal block refer
to (
Fig. 42).
The switch behaves just like a transmitter: each turn of the
key will cycle through an open/stop/close function.
NOTE:
Please refer to the Electric Key Switch unit’s
instruction sheet for installation procedure.
•
•
•
Accessories
30V PWR
A
U
X OUT
OPERA
T
E
GND
P.
E
O
V
P.
E
30V PWR
P.E
P.E 0V
GND
OPERATE
AUX OUTPU
41
Fig
42
Fig
