12
SecuraLift® Rhino
Installation Instructions & Owner’s Manual
C-Rail Assembly
Locate shaft into sprocket
Shaft
Track brac
ket (x2)
MARKER
DOOR
SHUTTLE
IMPORTANT NOTE:
Do not power up the drive
unit before assembling to the C-Rail.
Step 2 - Centre the Shuttle
If not already disengaged, fl ick the yellow clutch
lever up, so that it sits perpendicular to the rail.
Thread the loose and of the manual cord through
the hole in the yellow clutch lever (Fig. 05).
Thread down to red toggle (near the cord’s warning
tag) and knot through the spare hole.
Test if secured properly by pulling back towards
sprocket end to engage, and the towards door end
to disengage.
Once the cord is attached, move the shuttle to the
MARKER, which is located in the centre of C-Rail
(Fig. 06).
Step 3 - Secure the Drive Unit
Locate and insert the drive unit’s shaft into the C-
Rail’s sprocket as shown in (Fig. 07).
Fix the two track brackets as shown in (Fig. 08). Fix
with the four screws supplied in accessory pack.
a.
b.
c.
d.
e.
a.
b.
06
Fig
07
Fig
08
Fig
05
Fig
