Installation Instructions & Owner’s Manual
SecuraLift® Rhino
21
33
Fig
33
Fig
Coding Transmitters
Step 17.1 - Storing the Transmitter Code
The opener can only operate from transmitters that have
been programmed into its receiver. The receiver needs to
learn the codes of any transmitter that will be used with
the operator. Up to fourteen (14) codes can be stored in
the receiver’s memory.
Ensure that the battery is inserted into the
transmitter.
Press the CODE SET button and release. The
CODE SET LED will illuminate to indicate the
opener is in Code Learn mode. If a valid code is
not stored within 15 seconds the opener will exit
Code Learn (Fig. 33).
Press the transmitter button (one of four) that you
want to control the door. The CODE SET LED will
begin to fl ash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go
out.
The transmitter is now coded to operate the door -
press the button to test.
Step 17.2 - Setting the Transmitter to Operate
the Courtesy Light
Although the courtesy light comes on with each operation
of the opener, it may also be controlled by a transmitter
without operating the door.
Press the CODE SET button twice. The CODE SET
LED will illuminate and the courtesy light will turn on
to indicate that the light code learning is active (Fig.
34).
Choose a transmitter button not already coded into
the receiver. Press this button and the CODE SET
LED will begin to fl ash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go
out.
The transmitter is now coded to operate the light -
press the button to test.
a.
b.
c.
d.
e.
a.
b.
c.
d.
Press CODE SET
button once
Select one of the four
buttons you wish to
use to control the door
Press CODE SET
button twice
Select one of the
four buttons (not yet
programmed) you wish
to use to control the
courtesy light
