Installation Instructions & Owner’s Manual
SecuraLift® Rhino
23
37
Fig
38
Fig
Step 17.5 - Setting the Transmitter to Operate
Pet (Pedestrian) Mode
The opener can be programmed into a “Pet Mode” where
the door opens partially to allow pets to enter/exit the
garage:
Press the CODE SET button fi ve times, the CODE
SET LED will illuminate and the courtesy light will
fl ash quickly (twice per second) to indicate learning
mode for Pet Mode is active.
Choose a transmitter button not already coded into
the receiver. Press this button and the CODE SET
LED will begin to fl ash.
Press the same transmitter button again. The CODE
SET LED will illuminate for one second and then go
out, and the courtesy light will also switch off. This
indicates the code has been stored. This indicates
the code has been stored (Fig. 37).
Step 17.6 - To Erase Programmed Codes
If the CODE SET button is pressed and held for 6 seconds
the CODE SET LED will blink rapidly for one second to
indicate that all programmed codes have been erased.
(Fig. 38)
Step 17.7 - Installation of the Wall Mounted
Transmitter
Mount the transmitter in a convenient location, yet
out of reach of children and at least 1.5m off the
ground (Fig. 39).
Make sure the door is visible from this location.
To set the transmitter codes refer to Step 17.1 on
page 19.
a.
b.
c.
a.
b.
c.
Press CODE SET
button fi ve times
Select one of the
four buttons (not yet
programmed) you wish
to use to control the
door for pet position
Coding Transmitters
39
Fig
