8
NeoSlider
TM
- Sliding Gate Opener NES-24V3
Owner Installation Instructions
6. Programming The NeoSlider
TM
6.1 Common Programs
The two most common programs are;
Program
Menu’s required
Function
Section
Automated Set Up
Menu 10.1
Setting the Limits
8.1
Safety Obstruction Force
9.1 and 9.2
Menu 1
Coding the Transmitter
10.1
Automated Set Up with
Safety Beams
Menu 10.1
Setting the Limits
8.1
Safety Obstruction Force
9.1 and 9.2
Menu 1
Coding the Transmitter
10.1
Menu 3
Auto Close Times
13.2, 13.3 and 13.4
NOTE:
Fitting Safety Beams enables the Auto-Close feature to become active.
CAUTION:
Before plugging the gate control system in, check
the power cord for damage and ensure it cannot become
entangled in any moving parts
6.2 Powering up the NeoSlider
TM
a. After checking the initial wiring, apply power to the NeoSlider™. The
controller will go through a startup sequence displaying the STARTUP
SCREEN which indicates the controller type and firmware version
(Fig. 6.2)
. After a short delay the MAIN SCREEN will be displayed.
b. If this is the first time the NeoSlider™ has been used, the MAIN SCREEN
should indicate that the limits are not set
(Fig. 6.3
)
. If the display shows
that some input is active then rectify the situation before proceeding. If
a default setting is to be changed it should be done now before setting
the travel limits.
Fig 6.2
Fig 6.3
Fig 6.1
A.T.A NES-24V2
Firmware #.##
Limits not Set!
Press <> to access MENUS
Start up screen
Main screen
