Owner Installation Instructions
NeoSlider
TM
- Sliding Gate Opener NES-24V3
13
Fig 9.1
Fig 9.2
Fig 9.3
10. Coding Transmitter
NeoSlider
TM
can store up to thirty (30) transmitters in its
memory. Each transmitter can be allocated an alpha-numeric
ID label up to eleven (11) characters in length and each
button can be assigned to one of several control functions.
The settings for a transmitter are represented in
(Fig. 10.1)
.
It shows the transmitter’s store number, ID label or serial
number and the functions assigned to each of its four buttons.
To toggle between ID/SN display, press UP/DOWN with the
cursor on the ID/SN indicator. The procedures below code,
delete, replace, edit and copy transmitter records.
Fig 10.1
Fig 10.2
Fig 10.3
Fig 10.4
123
ID
Name/SN
OSC PED LGT VAC
I.D label/Serial
number
Button 4
function
Button 3
function
Button 2
function
Button 1
function
Store
number
ID/SN display
indicator
Menu 1
Code Transmitter
PRESS
Press Tx’er
Button LIST>
PRESS
# 1 [ No Name ]
OSC OFF OFF OFF
PRESS
PRESS
IMPORTANT NOTE:
Only TrioCode
TM
128 Technology Transmitters
are compatible with this product.
10.1 Coding Transmitter Button
Navigating To Menu 1 “Code Transmitter”
a. Press NEXT to navigate to Menu 1
(Fig. 13.2)
.
b. Press SET to enter the code set procedure.
Storing Transmitter Code
c. The controller will prompt to press one of the transmitter’s
buttons.
d. Press the transmitter button you wish to use to operate the
Gate Opener (e.g. button 1)
(Fig. 10.3
) .
e. Press the same transmitter button again as prompted by
the display
(Fig. 10.3
).
10.2 Selecting Function Of The Button
The controller will now show the transmitter’s record, with a
cursor on the field for the button being coded
(Fig. 10.4
)
.
Use UP/DOWN arrows to select the function for the button.
Available functions:
VAC (Vacation Mode) LGT (Courtesy Light)
STP (Stop) OPN (Open)
CLS (Close) SWP (Swipe)
PED (Pedestrian access) OSC (Open/Stop/Close)
OFF (No action)
Press SET to save the settings or EXIT to abort without saving
.
10.3 Returning To Main Screen
The “Code Transmitter” menu will now be shown. Press EXIT
to return to the MAIN SCREEN and test the transmitter.
