Owner Installation Instructions
NeoSlider
TM
- Sliding Gate Opener NES-24V3
9
WARNING: When using Safety Beams, the gateway must be clear of all obstructions and persons at all times.
The location of the beams and manner in which it is installed might not give safety protection at all times.
Check to make sure that the height of the beam and type used give maximum protection possible
WARNING: Tampering with Safety Beams could result in serious personal injury and/or property damage and
will void the warranty.
7.1 Installation of Safety Beams to the NeoSlider
TM
a. Follow the Installation Manual provided with the Safety Beam to
correctly install the Safety Beam.
b. By default the NeoSlider™ will take two wire safety beams.
c. Ensure you program the NeoSlider™ to idenitfy what type of Safety
Beam or combination of Safety Beams you have installed.
i. Press NEXT to Navigate to Menu 7
ii. Press SET to display Menu 7.1 (for SB1).
iii. Ensure the Safety Beam type is set to two wires.
iv. Press SET to accept the selection.
v. Repeat the same process for Menu 7.2 (SB2) if installed.
NOTE:
Wireless Safety Beam functionality is equivalent to 2 WIRE Safety
Beams
vi. NOTE:
The Power control for one or both three wire beams is
controlled via OUT 1 or OUT 2. To use the OUT 1, connect black
wire from SB to OUT 1. To enable power control from OUT 1, go to
Menu 7.13 and change OUT1 mode to 3 wire SB 0V.
NOTE:
In the case that OUT 1 is used for some other function, OUT 2 can
be used to control 3 wire beams power. Connect the black wire from SB
to OUT 2, then change the OUT 2 mode in Menu 7.14 to 3 wire SB 0V.
7. Safety Beams
7.2 Safety Beam Failure Emergency Close (SBFEC)
When the user finds that they are unable to move the gate and suspect that it is due to a faulty SAFETY BEAM they
can attempt to enter Safety Beam Failure Emergency Close mode by pressing and holding a pre-coded button on
the remote control or OPEN/CLOSE button on the console for more than five seconds. the gate will start closing.
See Appendix C Menu 7.16.
