INSTRUCTIONS CABRI-20P
Page 13
SWING GATE OPENER
13. Fasten the nut tightly and loosen it for half round for motor supporting in rotating.
14. Fasten the motor front end to the front plate with the bolt (A) and nut (B) tightly.
Fully tighten the screw.
15. Use appropriate key to release the gear motor.
16. Try to push the released gate and make sure the motor can be manually moved
easily.
17. Make sure the motor front plate can be fastened on the gate to be installed
permanently.
18. Use appropriate Key to fasten the gear motor again.
19. Loosen the plastic nut under the power cable of the motor end, and penetrate the
power cable through the nut and screw it up.
20. Connect the motor power cable as shown in Figure23.
22. Close the gear motor cover by tightening the two screws as shown in Figure24
Figure 23 Figure 24
CABRI-20P
23.
Gear Motor Release
1). Insert the release key to the release slot Figure25.
2). Turn the release key anti-clockwise Figure26.
3). Pull out the release bar Figure27.
4). Turn the release key clockwise to fix the release bar, the release bar has to be in
pulled out position when you turn the release key clockwise Figure28.
5). The turning direction will be reversed for right motor
