AutoGate VPL-24/UL, Инструкция по установке и эксплуатации

Страница: 10 / 46

I
NSTALLATION
I
NSTRUCTIONS
NOTE: Before attempting any part of the installation, you
MUST read the entire Installation Manual and Appendix A.
I. SITE PREPARATION:
A. Concrete Pads
Concrete pads are required to install your VPL Operator, Yoke & Gooseneck.
If applicable, (See Dwg. #101).
NOTE: Operator & Yoke pads MUST be poured on the same
grade and be level.
1 . Contoured gate grades may be an exception; check your order.
2. Certain special yokes do not require a pad; check w/site Dwgs. for installation.
B. Operator Pad Options:
1. Full Pad, Minimum depth of 36" or below local frost line (See Dwg. #101).
2. 10"-12” thick pad with four (4) 12" dia. x 36" deep holes or below local frost line (See Dwg.
#101).
NOTE: All pads need to be level and smooth for ease of installation
NOTE: Refer to Dwg. #101 for all applicable conduit locations
II. RECOMMENDED INSTALLATION TOOLS AND EQUIPMENT FOR INSTALLING
GATE & OPERATOR
Lifting Strap Multi-Meter (DCV & AMPS) ½” Drive Socket Set:
Hammer Drill, 1/2 & 5/8 Bits Grease Gun, Lithium
Grease 9/16”, 3/4”, 15/16”, 1-1/8”
Tape Measure Screwdriver Sets (Flat &
Phillips) Open End Wrenches:
9/16”, 3/4”, 15/16”, 1-1/8”
Hammer Level
III. RECOMMENDED INSTALLATION TOOLS AND EQUIPMENT FOR INSTALLING
ACCESSORIES
Wire
Cutters/Strippers Electrical Tape Misc. Electrical
Connectors Misc. 18 Ga. Strand
Wire
Chalk Line Amp. Meter Batteries
NOTE: Refer to manufacturer’s instructions of Accessory Equipment for correct wire size and
type.
NOTE: (2) 12 VDC batteries are required and not normally provided. Deep cycle marine
batteries are recommended.
1.800.944.4283 AutoGate Technical Support
9