AutoGate VPL-24/UL, Инструкция по установке и эксплуатации

Страница: 14 / 46

I
NSTALLATION
I
NSTRUCTIONS
B. Connecting Batteries - Required
WARNING: Do not attempt to connect Batteries or power-up Gate & Operator
until all Accessories have been completely connected & checked. This will prevent
an accidental “short” of your system while wiring accessories.
1. Install (2) 12 VDC Batteries (not always include; check your order) on the battery shelf.
See drawing below for proper hook up. Use minimum 7 AH batteries for minimal battery back up
or deep cycle marine batteries for extended battery back up.
NOTE : Battery back up operation will depend on the size of batteries and / or the number of
accessories powered by the batteries.
2. Install Jumper Wire (provided) from Batt. #1 - POSITIVE to Batt. #2 - NEGATIVE ( See
Below).
3. Locate RED and BLACK Power Wires and connect:
1.800.944.4283 AutoGate Technical Support
13
C. Testing
1. Remove T/M Safety Pin from front of Operator and hang it on the hook provided inside
access door.
NOTE: It may be necessary to push down on end of gate in order to take pressure off T/M
Safety Pin.
2. Temporarily remove any wires in the main circuit board Terminal #5 (rev. / safety) to disable
any Reversing/Safety devices not installed from preventing the gate from closing. (See Board
Dwg. #113)
3. Turn Main DC Power Switch “ on” . (Located under the Control Box) Use a hand-held
transmitter or the Push Button (not on all models, See Dwg. #103) to test your gate system.
The push button located on the end panel is controlled by the toggle switch mounted at bottom
of Control Box (See Dwg. #103).
NOTE: Your gate should activate and open in approximately 10-12 seconds. If your gate does
not lift properly, refer to "Troubleshooting Tips".
12 VDC Battery
12 VDC Battery
Black Lead
Jumper
Red Lead
BLACK TO BATT. #1 - NEGATIVE
RED TO BATT. #2 - POSITIVE