AutoGate VPL-24/UL, Инструкция по установке и эксплуатации

Страница: 20 / 46

M
AINTENANCE
I
NSTRUCTIONS
VI. MANUAL OPERATION
A. Your VPL gate is easily operated manually in the event of total power or component failure.
1. Turn main power switches off (both A/C & D/C).
2. Release the belt tension lever located under the gear motor to remove the belt tension.
3. Position yourself in front of operator and lift up on Linkage Arm at the pivot point 1”-2”. (See
dwg. #103).
4. Walk out to end of gate and lift gate to the open position.
NOTE: It only takes 16 - 30 lb. of force to open gate. If more is required, contact your
dealer or factory.
5. Place the T/M pin through the bracket holes to prevent the gate from lowering.
6. Secure the belt tension lever in the locked position to re-apply tension to the belts.
VII. MAINTENANCE
The Basic electric and mechanical systems require only minimum routine maintenance. The following
items should be checked and serviced periodically depending on amount of use. (See Dwg. #103 for
lube locations).
ITEM RECOMMENDED
MAINTENANCE
Grease pivot pins on Linkage Assembly
(“LUBRIPLATE ‘R’ LOW TEMP” Grease) 10,000 cycles or 6 months
Grease all bearings (2) Operator Arm, (2) Bullwheel Shaft every 6 months
Grease Chain Tension Bolt and Lube Chain every 6 months
Check belts for wear and tightness
(Belt flex is 1/4” – 1/2” top & bottom between output sheave &
bullwheel) every 6 months
Check battery water level, use distilled water only
(Not required on maintenance-free) every 6 months
Clean snow/ice off of gate
(Bal. Correctly, gate will temporarily tolerate an add’l 10 lb. of
wt.) as needed
Clean lenses on Photocells or Reflectors as needed
Lubricate (Graphite Oil) all lock cylinders every 6 months
Check and verify proper operation of all secondary entrapment
devices.
every month
Check and verify proper operation of all primary reversing
feature. (see Section V, Item #2-A)
every week
1.800.944.4283 AutoGate Technical Support
19