AutoGate VPL-24/UL, Инструкция по установке и эксплуатации

Страница: 12 / 46

I
NSTALLATION
I
NSTRUCTIONS
B. Positioning Operator:
For positioning operator on pad with gate center line and conduit placement (See Dwg. #101).
NOTE:
Allow concrete to cure a min. of (3) three days before setting Operator & Gate Assembly.
NOTE: If using a Forklift to position Operator only, lift from sides only ! Do not try to lift gate and
operator together from the side! (See Dwg. #103).
C. Lifting Gate & Operator:
To lift Gate & Operator, (Front End Loader, Forklift or Wrecker with Telescoping Boom) use a towing
strap or a lifting chain. The strap should be secured around Operator Arm and T/M Safety Pin or the
top rail of the gate near the operator arm. (See Dwg. #103).
NOTE: It is recommended to attach Gate to Operator Arm before lifting (for better balance), but it is
not mandatory.
D. Positioning Operator & Gate:
1. Place Gate & Operator Assembly on pad so the end of the Gate is centered over the Yoke
pad. Allow a minimum 3" from edge of pad to bolt holes to prevent concrete damage (See Dwg.
#101 & #102).
2. Position and align Pad Yoke and center under gate. (See Dwg. #101)
3. Secure
Operator with (1) 5/8" dia. Wedge Bolt in rear; check alignment.
4. Install remaining (3) 5/8" dia. Concrete Anchor Bolts provided, level Gate & Operator on
pad, if necessary.
5. Secure Yoke with 1/2” dia. Anchor bolts (provided).
NOTE: If installing a Ground Yoke, allow a minimum space of 2" between bottom of Gate and Yoke.
E. Wind bracing:
1. If ordered , attach wind bracing to gate with Galvanized Nuts provided on the rods or cables;
one nut attached near operator and one attached at gate bracket (See Dwg. #I-105-1 & 2.).
Tighten each side equally.
Fasten KICKPLATE
to door side of
operator as shown.
F. Kick Plate:
1. Attach the kick plate to the door side
of the operator using the 5 - #12 x 3/4 tek screws.
G. Gate Guard:
1. Install gate guard on the
Fasten Gate Guard
back side of the operator.
1.800.944.4283 AutoGate Technical Support
11