AUTOFLAME Mini Mk8 M.M., Руководство по установке и пусконаладке

Страница: 100 / 125

100
5 ERRORS AND LOCKOUTS
错误和锁定
5.1 M.M. Errors
控制模块错误
Error
错误
Message
错误信息
Description
描述
1
Channel 1 Positioning Error
频道
1
定位错误
Servomotor is outside of the commissioned range
伺服马达运行超出调试范围。

Check wiring on terminals 40 – 47
检查接线端子
40 – 47
的接线。

Check signal cable from the M.M. to the servomotor is screened at one end

检查从控制模块到伺服马达的信号电缆是否被一端屏蔽。

Check potentiometer is zeroed correctly
检查电位计是否被正确调零。

Go into Commissioning mode, check the servomotor position and ensure that closed is
at 0.0
O
进入调试模式，检查伺服马达位置，确保其关闭位对应
0.0
O
2
Channel 2 Positioning Error
频道
2
定位错误
Servomotor is outside of the commissioned rang
伺服马达运行超出调试范围。

Check wiring on terminals 40 – 47
检查接线端子
40 – 47
的接线。

Check signal cable from the M.M. to the servomotor is screened at one end
检查从控制模块到伺服马达的信号电缆是否被一端屏蔽。

Check potentiometer is zeroed correctly
检查电位计是否被正确调零。

Go into Commissioning mode, check the servomotor position and ensure that closed is
at 0.0
O
进入调试模式，检查伺服马达位置，确保其关闭位对应
0.0
O
3
Channel 3 Positioning Error
频道
3
定位错误
Servomotor is outside of the commissioned range
伺服马达运行超出调试范围。

Check wiring on terminals 40 – 47
检查接线端子
40 – 47
的接线。

Check signal cable from the M.M. to the servomotor is screened at one end
检查从控制模块到伺服马达的信号电缆是否被一端屏蔽。

Check potentiometer is zeroed correctly
检查电位计是否被正确调零。

Go into Commissioning mode, check the servomotor position and ensure that closed is
at 0.0
O
进入调试模式，检查伺服马达位置，确保其关闭位对应
0.0
O
5
Channel 1 Gain Error
频道
1
增益错误
Servomotor position measurement hardware error
伺服马达位置测量硬件错误

Check wiring and voltages on terminals 40 – 47 and if no fault found, contact Autoflame